![]() For example: To replace the 1-cylinder to 2-cylinder injector, just select the numbers “1” and “2”. After the injector correction code has been entered, select “Apply” to proceed according to the procedure prompt until you see the message that the new correction code was successfully sent to the ECM.Īfter setting the injector barcode, enter “Advanced ECM Data”-“Injector Reset” Ĭlick to select the cylinder number of the replaced fuel injector. In the “New Barcode” field, enter the injector correction code for the corresponding cylinder. Select “Advanced ECM Data” – “High Pressure Common Rail Injector Settings” – “New Bar Code” Do not directly open the Inline 8.3 after installed, you need to go through the. Need to confirm by server and it may take some time, after success, the software is combined with your computer. Inline7 runs the same driver as Inline6 2. ![]() ![]() Stop the engine and connect INSITE service software to ECM Cummins Insite 8.3 Download Software Using And Activation Tips 1. After the INSITE software opens, click on Connect to ECM. Turn on the vehicle and turn the key to the ON position. Open the INLINE connector located on the front of the passenger seat, connect INLINE (note the connection direction), and connect the other end of the INLINE to the computer. Install Cummins Insite and the License Configuration Tool through the DVD or directly download from Cummins website here, and restart the PC. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |